What did you do for your M3 today?

[WestBankM4]

Alright, back on the road. Feels like a brand new car internally. Engine, suspension, interior done and now, the exterior.

Dynavin 9
BavSound Stage 1
Recaro Sportster CS
Complete black interior swap
Brought over my Aluminum trim
Euro short console
PedalHaus aluminum pedals
Latvian Steering Wheel Alcantara
AKG Bronze/Delrin Brake and Clutch bushings
Repaired GM5
Cluster MT insert

I LOVE THIS CAR!

Sent from my Pixel 9 Pro XL using Tapatalk

[kaiv]

Took it out for a joy ride. Running the Bryson mullet tune... The S54 is such a manic animal!

[DJAM3]

New inserts for the Pole Positions

[0-60motorsports]

New inserts for the Pole Positions

Wow that looks good

[6speedS54]

So my 2004 red convertible of 12 years and 173K miles was totaled in September by a motorcycle. I picked up a 2006 Carbon Black convertible with 119K miles. Here are some items I have done over the last month to freshen it up and bring it up on maintenance.

Center console refresh
Stock shifter knob
ECS front brake rotors
Trunk struts
Hood struts
Missing plastic fasteners all over the car
New headlight trim
New End Links
New Valeo Starter, no crank no start
ICV cleaned
Engine bay TPS Sensors
New Temperature Sensor
New Guibo
New CSB
New Rogue Transmission mounts
Exhaust hangers
Fuel Filter

[Gt4]

New inserts for the Pole Positions

Are you going to do rear seat and door inserts too?

[PSUEng]

Well, I did this last week, but forgot to post. Finally my last interior piece for the time being, refinished by none other than Alex...100% satisfied as usual.

[DJAM3]

Are you going to do rear seat and door inserts too?

I wasn't planning to. I think that would be a bit much. I liked having fabric seats and I wanted to break up the all black interior after I swapped in the black trim. I also like the flexibility to change the inserts again down the road if I wanted. I might pick up a spare dash trim set and cover it in houndstooth for fun.

[Projecte46m3]

3.5L Stroker Engine Build Prep...

Arrow Precision Crankshaft 97mm
Arrow Precision Rods
CP 12:5.1 Pistons
Schrick 288/280 cams w/ rocker arms
Supertech Valvetrain w/ lash cap conversion kit
Bored 87.5mm block
Diff Lab engine girdle kit
Slight port work and valve job on the donor cylinder head
All new bolts, accessories, vanos, etc..!
Radium fuel system upgrades - rail, lines, filter
Walbro 485lph fuel pump
Bosch 550cc injectors
eFlex Fuel Pro e85 kit

[6speedS54]

Over the last 2 weekends:

Oil Sensor
Oil Change
CPV O-Ring
Replaced fuel pot rubber
Front convertible top fixes
- motor replaced (noise),
- motor gears replaced with brass,
- front motor cover replaced,
- added missing rubber isolator screw
Replaced cracked Mount F/Wind deflector clips (cost left kidney)
All Pulleys and Tensioners replaced
Replaced alternator
Dynavin HVAC relocation bracket
Fixed Clock adjustment/Instrument cluster (https://www.ebay.com/itm/174414757236)

[davidinnyc]

Started working through an OEM navigation retrofit (I know, there are better units that require no effort to install) and found this little guy tucked away behind the dash.

Anyone want it?





Sent from my iPhone using Tapatalk

[PSUEng]

Started working through an OEM navigation retrofit (I know, there are better units that require no effort to install) and found this little guy tucked away behind the dash.

Anyone want it?





Sent from my iPhone using Tapatalk

I had one of those!!! Ended up causing a glitch with my turn signal blinker so I removed it. Not to suggest yours is bad or anything, I think mine developed a fault. I have the original install instructions in pdf if anyone needs it.

[PSUEng]

Car went in last week to the indy shop I've used for years for a FR suspension refresh at 86k miles after having noticed the front just felt "loose"; all original parts were still on the car at this point.

Replaced: LCAs, FCAB, sway bushes, sway links, rebuilt yellow tag rack and new steering coupler.

Encountered another issue during alignment, so had new Turner adjustable LCAs, the outer lower ball joints and sway links replaced (bushes done 2 years ago with all new diff bushings). Can't wait to drive this thing, getting it back tomorrow. I'll say, just handling the old parts, it is amazing how much difference in play there is compared to the new stuff.

[repoman89]

Not an M3 but my E39 is all I have left for my old BMW fix. Got a new Brembo GT kit front and rear installed on the car which solves all of my many complaints about the stock brakes. It’s overkill maybe but this was my treat for selling my E46. Ignore the filth, the car is living outside temporarily while I have some construction done on my house.

[BTB]

A little bit of magic eraser and I think I can hold off on a Coby wheel refresh for another year ..